4 Steps To Follow After A Pipe Burst

Nobody can deny that owning a home is a big expense, especially if it’s a mature model. When it comes to a water pipe burst, the damage to your home, your belongings, and your health can be serious if the mess is not properly cleaned. When a pipeline in your house explodes, you have to follow four steps.

1. Stop The Water

First stop the flow of water if you suspect a pipe burst, even if you do not know where the water is coming from. You will find the stop on the water pipe. It is usually found under the sink or where the main line connection to your home. Each family member should know the location of the emergency tap. If the main water switch is off, you must drain the lines. Let all taps run with cold water. Be sure to rinse each toilet at least once. Turn off the boiler. Once the hot water system is closed, return to each faucet and run the hot water to empty this supply. If there is no running water, the leak stops.

2. Locate The Pipe Burst And Examine The Damage

After draining the excess water, locate the pipe. Check the damage and consider where the pipe is before you go to the hardware store. Regardless of the damage or size of the break, a larger water pipe will require more time and effort to replace it because it contains more water and results in additional joints, as opposed to a single pipe below the sink. If it’s a short break, you may be able to repair it and avoid further damage while saving money. However, if you are using commercially available tape or a chemical primer, you should monitor this repair work as it can explode later and return to where it started.

3. Repair The Pipe Burst

Repairing a break or a crack in non-main pipes is usually fairly simple, but can be expensive depending on the repair material you choose. Here is a cost-effective repair for small cracks and water breaks, which also gives you excellent adhesion. You will need a normal garden hose of very long length and two or three clamps or similar handles that create an extreme constriction. Measure the pipe burst or tear and cut the garden hose about ten inches longer than necessary to fill the cracked area.

Next, cut the garden hose so that you can push it over the crack or burst into the water pipe. Hold the hose section with hose clips or similar clips on the bursting area and squeeze it as tightly together as possible. Test your repair by turning on the water.

If the break is greater, use a hacksaw to cut off the blown part of the pipe. Make sure to cut about an inch more on each side of the pipe burst. When replacing the missing pipe section, use pipe separators and sealants, but do not over-tighten. If a compression nut is too tight, it causes an oval effect that leads to more leaks. If you over-tighten the union nut and repair the ovals, start with another union nut.

4. Bring Professional Drying Equipment

If the water in the burst tube is on walls or ceilings, as well as on the floor, contact a professional water utility for water damage restoration in Palm Beach County. The simple fact of using fans and opening windows to dry a damp area is an invitation to molding and even a serious illness for your family. You should also break the power supply in this area of ​​the house as a precaution against shocks.